CCTV Video Balun with built-in Ground Loop isolator

BNC Male to 2 pin terminal block. Built in Video Balum for Tranmittting a full motion monochrome video signal up to 150meters.

Eliminates Coxial Cable Passive no power required

Prevents video signal distortion caused by video ground loops.

Elimanates picture tearing cross talk and rolling.

Prevents power cables laid by others interfering with the CCTV system.

Built in TVS (Transient Voltage Supression) for surge protection.

Helps eliminate pictures that tear up or have intermittant problems, possibly caused by irregular use of industrial or other heavy equipment, which may interfere with the CCTV picture.

Two baluns are required, one on either end.

This balun converts the signal to a 100ohm unbalanced, allowing the video signal to be transmitted using CAT5, (UTP), cable instead of coax, over a maximum distance of 150m, (Mono)and approximately 100m for a colour picture, depending on the camera used